0
dis3dprintlogo
0
Have you seen our United States website? Visit USA today!
We also have websites for: Visit USA Visit USA Visit USA Visit USA Visit USA Visit USA Visit USA

Gaoominy 3D CNC Shield Board for R3 + 4Pcs A4988 Stepper Motor Driver for 3D Printer

Price: £5.80
Product prices and availability are accurate as of 2020-11-26 19:45:34 UTC and are subject to change. Any price and availability information displayed on https://www.amazon.co.uk/ at the time of purchase will apply to the purchase of this product.
Availability: In Stock
In stock.
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Product Description

We are happy to stock the brilliant Gaoominy 3D CNC Shield Board for R3 + 4Pcs A4988 Stepper Motor Driver for 3D Printer.

With so many on offer today, it is good to have a make you can trust. The Gaoominy 3D CNC Shield Board for R3 + 4Pcs A4988 Stepper Motor Driver for 3D Printer is certainly that and will be a perfect acquisition.

For this great price, the Gaoominy 3D CNC Shield Board for R3 + 4Pcs A4988 Stepper Motor Driver for 3D Printer comes widely recommended and is a popular choice for lots of people. Gaoominy have provided some excellent touches and this equals good value.

Product Features

Coolant enable,Uses removable A4988 or DRV8825 compatible stepper drivers Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping ).Compact design.Stepper Motors can be connected with 4 pin molex connectors or soldered in place. Runs on 12-36V DC. (At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.),Please note that this is an unassembled kit and Basic soldering skills are needed.A4988 Stepper Motor Driver Board is a breakout board for Allegro's A4988 DMOS Micro-stepping Driver with Translator and Overcurrent Protection; please read the A4988 datasheet carefully before using this product. CNC Shield Board: Latest CNC Shield Version 3.0 for .GRBL 0.9 compatible. (Open source firmware that runs on an for that turns G-code commands into stepper signals).PWM Spindle and direction pins.4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13).2 x End stops for each axis (6 in total) Low RDS (On) Output,Automatic current decay mode detection / selection,Mix with slow current decay modes.Synchronous rectification for low power dissipation,Internal UVLO.Crossover-current protection,3.3 and 5 V compatible logic supply,Thermal shutdown circuitry,Ground fault protection,Load short-circuit protection,Five selectable step modes: full, 1/2, 1/4, 1/8 and 1/16.

Write a Review